Formlabs

The Ceramic Wash Solution is a specialized wash liquid for cleaning ceramic 3D printed parts. A wash in this solution is required for parts printed in Alumina 4N Resin. Ceramic Wash Solution is non-hazardous and non-flammable.

Patented Quick Release Technology allows you to quickly and easily remove 3D printed parts from the build platform without tools in seconds. Compatible with Form 3L and Form 3BL printers.

The Fuse Sift Replacement 300 Micron Sieve helps separate out powder for recycling during the sifting process. 

Required for use with Formlabs Nylon 11 CF Powder printed on the Fuse 1+ system.

Build Platform 2 with patented Quick Release Technology allows you to quickly and easily release parts from the build platform without tools in seconds. Helps eliminate risks of damaging parts during removal and streamlines printing workflows.

The Form Wash L automates the print washing process and provides consistent, thorough, no mess cleaning for parts printed on the Form 3L and Form 3BL.

The Form Cure L precisely combines temperature and 405 nanometer light to post-cure parts for peak performance.

The 37 L (9.8 gallons) stainless steel Rinse Bucket V2 fits full-size Form 3L parts and makes it simple to wash parts printed on Form 3L/3BL.

• Rinse Bucket
• Rinse Basket
• Grounding Cable
• M5 Grounding Stud

The Form 3L Finish Kit helps keep your workspace clean and organized while putting the finishing touches on your large format 3D printed parts.

• Rinse Bucket/Basket
• Grounding Cable/M5 Grounding Stud
• Build Platform Jig
• Battery-powered Solvent Pump
• Cleaning Tools

The Fuse 1 Optical Cassette should be cleaned between each print. Keep additional on hand for fast swapping to minimize downtime between prints.

The Fuse Sift Replacement 150 Sieve helps separate out powder for recycling during the sifting process. 

The Fuse Sift Replacement HEPA Air Filter should be replaced as needed. Maintenance notifications will prompt when the filter is approaching the end of lifespan and replacement is required.

The Fuse 1 Replacement Air Intake Filter should be replaced as needed. Maintenance notifications will prompt when the filter is approaching the end of lifespan and replacement is required.

The Fuse 1 Replacement Air Exhaust Filter should be replaced as needed. Maintenance notifications will prompt when the filter is approaching the end of lifespan and replacement is required.

The Fuse 1 Powder Cartridge is designed for simplified powder mixing and transfer between the Fuse 1 and Fuse Sift. Add additional Powder Cartridges to enable continuous printing and reduce downtime. Industry leading cooldown times allow new prints to be started 1-2 hours after the previous print has finished.

The Fuse 1 Build Chamber is designed for maximum throughput. Add a second removable Build Chamber and additional Powder Cartridges to enable continuous printing and reduce downtime. Industry leading cooldown times allow new prints to be started 1-2 hours after the previous print has finished.

Resin Tank V2.1 for Form 3 / 3B.

Low Force Stereolithography 3D printing uses linear illumination and a flexible film tank to turn liquid resin into flawless parts. A key component of the LFS process, the strong dual-layer film at the bottom of the Form 3 Resin Tank allows for a dynamic and precise print process.

Compatible with all Formlabs resins, required for printing Formlabs Castable Wax 40 Resin. Resin tanks are considered consumables.

Build Platform for Form 3L.